Frame Design installation guide
Every Frame Design arrives as nine clear-gloss printed pieces. Lay them against your bike first and decide where each graphic works best. The kit is trim-to-fit, not model-specific.
Approximate piece sizes
For planning only: three long frame pieces are each about 40 cm long and roughly 3–4 cm wide; the two fork pieces are about 30 × 3 cm each; the two stay pieces are about 25 × 2 cm each; and the two smaller accents are about 15 × 2 cm each. These sizes are rounded up, not cutting dimensions. The complete nine-piece kit is supplied on an approximately A3-sized sheet. Check each piece against your own frame before applying.
How to apply
- Clean and dry the frame; remove grease, dust and residue.
- Hold the pieces in position and plan the layout with the backing still on.
- Trim where needed before application. Never cut directly against the bike.
- Peel the backing gradually and press from the centre outward.
- Finish the edges carefully and check that every piece is secure.
Transparent gloss vinyl lets the original frame colour remain part of the finished look. On matte paint, the applied areas will have a subtle gloss contrast. Frame shapes and tube sizes vary, so check fit and finish before you peel.